Mass Points Processor (7.0)

Functionality that is common to two or more packages
twdotson
Site Admin
Posts: 185
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Mass Points Processor (7.0)

Postby twdotson » Mon Jun 11, 2018 10:04 pm

The Mass Points Processor was introduced and has been evolving for years. We recently added what could be considered the best improvement yet, the ability to download directly using it eliminating the need to jump through the usual hoops with a browser.



Note that in the initial release it only contains support for USA, Kentucky. However, we will be continually looking for other states and agencies that provide the intelligent data resources needed to make this work.

twdotson
Site Admin
Posts: 185
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Re: Mass Points Processor (7.0)

Postby twdotson » Wed Jun 13, 2018 9:22 pm

When an agency supplies .LAS files (even inside a ZIP) we convert to .LAZ for maximum compression. For example (Ohio files) the resulting .LAZ was 2.5 times smaller than Zipped LAS files.

We have found that several US states provide for the 5000'x5000' tile approach and we will continue to add these as time allows. If you suspect your agency may be a candidate, contact us. To be a candidate there must be a logical tile grid where the filename contains (part of) the north/east coordinate and direct file download (no delayed ordering, etc).

twdotson
Site Admin
Posts: 185
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Re: Mass Points Processor (7.0)

Postby twdotson » Wed Jun 20, 2018 5:05 pm

Currently supported agencies:

  • USA, Indiana East (IN83-EF)
  • USA, Indiana West (IN83-WF)
  • USA, Kentucky (KY83F)
  • USA, Ohio North (OH83-NF)
  • USA, Ohio South (OH83-SF)


Return to “Common Functionality”

Who is online

Users browsing this forum: No registered users and 0 guests

cron