Page 1 of 1

DrwLabSlz command

Posted: Mon Nov 02, 2015 7:00 pm
by dkochel
I have the durndest time trying to get the slope label to appear the same way in all my drawings. It would appear it is driven by the current dim style (leader style?), but i cannot figure out which variables are influencing it. Ideally I want the slope arrow to appear centered in front of the slope text (not underlining it). I also need the arrow and leader to be as short as possible. I rarely have room for a large label. Can anyone provide some insight into how i can control this label? I'm thinking it will need a dedicated dim style - just need the right variables.

Re: DrwLabSlz command

Posted: Wed Nov 04, 2015 2:57 pm
by twdotson
Try setting your TEXTSIZE variable to a reasonable value?

This tool simply drives the LEADER command.

Re: DrwLabSlz command

Posted: Wed Nov 04, 2015 5:55 pm
by dkochel
looks like the DIMTAD variable was the primary culprit. needs to be 0 for centered text.