Page 1 of 2

Figure Adjust Segment

Posted: Mon May 25, 2015 6:28 pm
by twdotson
Adjusts one end of a figure to a specified slope distance, specified elevation, or intersection of a selected surface.

Re: Figure Adjust Segment

Posted: Tue May 26, 2015 3:51 pm
by rkmcswain
Are you using the word "figure" to mean a Line, 3D polyline, Feature Line, and/or a true Figure?

Re: Figure Adjust Segment

Posted: Tue May 26, 2015 6:00 pm
by GIZMO-NJ
I believe this is the standard Dotsoft definition of "figure"

Re: Figure Adjust Segment

Posted: Wed May 27, 2015 11:43 pm
by twdotson
I think this tool should be able to work on any point along the figure and become Figure Adjust Point. I think that it might require the picking of a reference point since the adjustment might be forward on the path or it could be backward.

Re: Figure Adjust Segment

Posted: Thu May 28, 2015 11:13 am
by GIZMO-NJ
Sounds ok

Re: Figure Adjust Segment

Posted: Sun Jun 07, 2015 1:16 pm
by twdotson
This tool has been revised to work on any segment along the figure. Pick the segment near the end you want to move, the other will be held fixed. The base and pointer graphics (immediately after pick) make it obvious what's going to happen.

Re: Figure Adjust Segment

Posted: Fri Jun 12, 2015 11:53 pm
by Lincoln
This is demonstrating bizarre behavior...? Has this been tested in 2016?

"Index was out of range"

Re: Figure Adjust Segment

Posted: Sat Jun 13, 2015 5:17 pm
by twdotson
Yes, it has. We have tried to reproduce this and cannot. Can you provide a reproducible situation with details (email a drawing)?

Re: Figure Adjust Segment

Posted: Tue Jun 16, 2015 5:35 pm
by twdotson
Okay, should be fixed in today's build.

Re: Figure Adjust Segment

Posted: Tue Jun 16, 2015 9:33 pm
by Lincoln
Getting a hard fatal error crash now when simply trying to draw a Feature Line.

Uninstalled Gizmo and the problem went away.