Page 1 of 2
Polyline Set Elevation
Posted: Thu Apr 09, 2015 2:16 pm
by twdotson
Assigns elevations to polyline contours by simply striking a line across the polylines. Turn a large flat topo drawing into a workable 3D contour drawing in a matter of minutes!
Video Demo:
http://www.dotsoft.com/demos/csPlcSetElv.htm
Re: Polyline Set Elevation
Posted: Thu Apr 09, 2015 5:18 pm
by Lincoln
Where is this command located?
Re: Polyline Set Elevation
Posted: Thu Apr 09, 2015 5:20 pm
by twdotson
Sorry, it will be in tonights build.
Re: Polyline Set Elevation
Posted: Fri Apr 10, 2015 1:45 pm
by twdotson
Okay I just realized this was isn't on the menus yet because it starts a new category (panel).
For now you can use the command.
Command: PlcSetElv
Re: Polyline Set Elevation
Posted: Fri Apr 10, 2015 8:53 pm
by twdotson
This tool has been added to the pulldown menus (MENUBAR=1) but not a ribbon panel at this time.
Re: Polyline Set Elevation
Posted: Thu May 07, 2015 1:36 pm
by twdotson
Lincoln wrote:Where is this command located?
This tool like many less significant tools will be on the pull down menus. There simply is not room on the ribbon for everything but
everything is on the pull downs.
Command: MENUBAR 1
Re: Polyline Set Elevation
Posted: Fri May 08, 2015 6:54 am
by GIZMO-NJ
I can access via the command line but not when Menubar = 1 - no sign of Gizmo in the menu?
Re: Polyline Set Elevation
Posted: Fri May 08, 2015 1:04 pm
by twdotson
You may have to add the pull down to your workspace. The whole CUI has been a mess since day one.
Re: Polyline Set Elevation
Posted: Mon May 11, 2015 12:52 pm
by Lincoln
It's in the Workspace.. just not showing up with the others.
Re: Polyline Set Elevation
Posted: Tue May 12, 2015 6:45 am
by GIZMO-NJ
Is there perhaps a limit on the number of items that can be displayed in the Menubar?