Point Draw Linear (7.0)

Civil/Survey and GIS add-on for CAD engines.
twdotson
Site Admin
Posts: 167
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Point Draw Linear (7.0)

Postby twdotson » Sat Dec 02, 2017 5:21 pm

This tool draws linear objects by point number quick entry. It can draw arcs, lines or multipoint figures such as mult-lines, polylines, or splines.

Command: PntDrwLin

Arc: Prompts for three points along a curve (begin, middle, and end).
Line: Prompts for two points to form a line object (begin, end).
Other: Prompts for a starting point, then continuously prompts for a point number.
  • To end an open figure, simply press enter when prompted for the next point.
  • To close to the point of beginning, enter the beginning point number to close then press enter to end.
  • When a figure is drawn closed, it will create a figure with the closed flag set and the beginning point will not be duplicated.
  • The object drawn will normally be 3D if the point elevations vary. If the OSNAPZ variable is set to 1, a 2D object will be drawn at the current ELEVATION value.

Return to “MapWorks”

Who is online

Users browsing this forum: No registered users and 3 guests