The Build Thread (3.0)

Inside CAD pulling document information
twdotson
Site Admin
Posts: 194
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

The Build Thread (3.0)

Postby twdotson » Tue Jul 09, 2019 10:13 pm

This thread is for small (but important) revisions to this version.

  • (06-24-19) Added support for Word Tables, including merged rows/columns.
  • (06-24-19) Added support for Inline images (bitmaps).
  • (06-24-19) All dialogs reworked to better accommodate Windows font scaling (>100%).
  • (06-24-19) All code refined for faster processing (single transactions) on the CAD side.
  • (06-24-19) All CUI(x) ribbon icons refined with colored icons, etc.

With each revision, the installer MSI file has been revised. Existing users can update by downloading again using the link originally received and reinstall.

chillme1
Posts: 7
Joined: Wed Feb 03, 2016 5:59 pm

Re: The Build Thread (3.0)

Postby chillme1 » Tue Jul 09, 2019 11:53 pm

I just noticed that the documentation includes up through BricsCAD version 18 and does not include the latest BricsCAD version 19 in the installation instructions / table.

I understand that the latest BricsCAD version in the table can be selected to install this build. Correct?

I hope this is helpful for you.

twdotson
Site Admin
Posts: 194
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Re: The Build Thread (3.0)

Postby twdotson » Wed Jul 10, 2019 11:52 am

The documentation may lag (and will be updated) but if the autohook doesn't load it, choose the best DLL during netload. In this case the 19b.dll is installed.


Return to “WD2CAD”

Who is online

Users browsing this forum: No registered users and 1 guest

cron