Page 1 of 1

Figure Construct Mirror

Posted: Wed Apr 29, 2015 2:17 am
by twdotson
Creates a mirror image of a selection set of figure objects.

Re: Figure Construct Mirror

Posted: Wed Apr 29, 2015 3:37 pm
by GIZMO-NJ
There seems to be a problem with this somewhere if you answer N to delete source as it creates the new on on top of the original. If you say Y, it creates the new Object but leaves the original (I tested it on the drawing I emailed)

Also the new object is a 2D polyline - presume this is by design?

Re: Figure Construct Mirror

Posted: Wed Apr 29, 2015 5:00 pm
by twdotson
For quicker workup (of a tool that shouldn't be needed) and drag visuals we are trying to use the MIRROR command interactively. We may have to bypass the drag effects because we sure can't justify doing our own calcs and drag jig on this tool, we would pull it first.

Re: Figure Construct Mirror

Posted: Wed Apr 29, 2015 5:22 pm
by twdotson
We have tried asking for the points and option ourselves and passing them through to the mirror command. Run Check for Updates on a mid-day build and try to break it again.

Re: Figure Construct Mirror

Posted: Wed Apr 29, 2015 5:35 pm
by GIZMO-NJ
Not back in the office til Friday so will try it again then

Re: Figure Construct Mirror

Posted: Wed May 20, 2015 11:04 pm
by twdotson
This tool is being moved under the Figure Edit Commands.