Figure Construct Mirror

Productivity Tools for Civil3D 2015 or higher
twdotson
Site Admin
Posts: 166
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Figure Construct Mirror

Postby twdotson » Wed Apr 29, 2015 2:17 am

Creates a mirror image of a selection set of figure objects.

GIZMO-NJ
Posts: 28
Joined: Tue Apr 07, 2015 7:00 am

Re: Figure Construct Mirror

Postby GIZMO-NJ » Wed Apr 29, 2015 3:37 pm

There seems to be a problem with this somewhere if you answer N to delete source as it creates the new on on top of the original. If you say Y, it creates the new Object but leaves the original (I tested it on the drawing I emailed)

Also the new object is a 2D polyline - presume this is by design?

twdotson
Site Admin
Posts: 166
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Re: Figure Construct Mirror

Postby twdotson » Wed Apr 29, 2015 5:00 pm

For quicker workup (of a tool that shouldn't be needed) and drag visuals we are trying to use the MIRROR command interactively. We may have to bypass the drag effects because we sure can't justify doing our own calcs and drag jig on this tool, we would pull it first.

twdotson
Site Admin
Posts: 166
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Re: Figure Construct Mirror

Postby twdotson » Wed Apr 29, 2015 5:22 pm

We have tried asking for the points and option ourselves and passing them through to the mirror command. Run Check for Updates on a mid-day build and try to break it again.

GIZMO-NJ
Posts: 28
Joined: Tue Apr 07, 2015 7:00 am

Re: Figure Construct Mirror

Postby GIZMO-NJ » Wed Apr 29, 2015 5:35 pm

Not back in the office til Friday so will try it again then

twdotson
Site Admin
Posts: 166
Joined: Thu Mar 19, 2015 9:35 pm
Location: Flemingsburg, KY

Re: Figure Construct Mirror

Postby twdotson » Wed May 20, 2015 11:04 pm

This tool is being moved under the Figure Edit Commands.


Return to “C3D Tools Suite”

Who is online

Users browsing this forum: No registered users and 1 guest

cron